Adding Brew Pressure Gauge?

Post by **alsterling** » Mon Dec 25, 2006 6:40 pm

I would like to see how to add a brew pressure gauge to my Ver.1 machine...... Does anyone have instructions and photos, etc? I'm guessing that I would just "Tee" into the pressure side of the feed to the brew group?

Thanks, Al

Post by **admin** » Tue Dec 26, 2006 12:53 am

I think the part below from Espresso Parts might be just the ticket for a retrofit without having to modify the hole in the front panel. It should connect right up to the current boiler connection, then you'd just need to figure out the optimum place to tap into the group boiler lines. I plan to take some photos of how LaSpaz did this in the VII and post them here in the next few days.

Post by **alsterling** » Tue Dec 26, 2006 10:19 am

Chas.......thanks. I'll call both Espresso parts and Chris to see if they have any suggestions. It doesn't seem to be a very complicated issue, but I don't want to reinvent the wheel.

Best, Al