Page 1 of 1
Is this a typical day 1 leak??
Posted: Thu Jan 03, 2008 9:58 pm
by JohnB
Just got the V2 up & running tonight but looks like I'll be pulling that fitting tomorrow. Is there a How To on removing the top cover(cup warmer) somewhere on the site?
Posted: Thu Jan 03, 2008 10:05 pm
by Niko
John,
there's a single screw holding the top cup warmer.
Look right in the middle - outermost towards you at the edge. After that if should pull straight out, it's usually a little wedged in there but it lifts out easily.
(of course don't forget to remove the plastic guard rail first)
Are you talking about this little leak?
You can probably fix this with a little teflon tape.
Re: Is this a typical day 1 leak??
Posted: Thu Jan 03, 2008 10:40 pm
by chas
JohnB wrote:Is there a How To on removing the top cover(cup warmer) somewhere on the site?
Check out this page:
http://www.rimpo.org/s1/S1Photos.html
Posted: Thu Jan 03, 2008 10:40 pm
by JohnB
Thats the leak & I have a tube of pipe dope that works better then the tape. It is unfortunate that I have to take a brand new machine apart to fix leaks but I've owned Italian motorcycles long enough to not be surprised.
I did remove that screw & it didn't budge so I figured I'd check & see if there was another fastener hiding someplace. I'll be a little more aggressive with it tomorrow. I want to get a good look inside & see if there is anything else that needs attention.
Re: Is this a typical day 1 leak??
Posted: Thu Jan 03, 2008 10:44 pm
by JohnB
Thanks! Never thought to look in the Photos link, I was digging around in the tech/how to areas.