Rocky bur gear change
Posted: Fri Jan 02, 2015 3:12 pm
Ordered some bur gears for the DL Rocky grinder about a year ago. At the time thought the old burs were still good. Decided to change out today. Very difficult to remove the screws holding the burs but finally was able to remove. Cleaned up the grinder and installed the new burs. On reassemble I was unable to get the burs to chatter on the lowest possible setting. Removed and replaced 3-4 time. Compared to old and look the same. Could not figure out what I was doing wrong . Not much to replacing burs and aligning. So put in old burs and chatter no problem. So even thought they look the same, they are not. Call Chris coffee where I purchases them and talked to Tim. On the bag it said Rancillo 40 burs. On the bur It was marked Rancillo trademark and A.13. On the old, only the Rancillo trademark. Anyway, going to send back to Chriss Coffee so they can see if any difference.
Any one have this problem. Upgrading next month to a new Mazzer mini elctronic. Considered the a Super Jolly electronic but Tim mentioned Jolly quite larger and in his opinion would get about the same grind from the small grinder. Any thoughts.
Any one have this problem. Upgrading next month to a new Mazzer mini elctronic. Considered the a Super Jolly electronic but Tim mentioned Jolly quite larger and in his opinion would get about the same grind from the small grinder. Any thoughts.