Page 1 of 1

Pump gauge starting at 7bar

Posted: Sun Oct 07, 2018 7:29 am
by Bostonvivaldi
Hi everyone,
Is there away to reset the pressure gauges? The pump gauge is dialing 7 bar even when the machine is turned off. When brewing it reaches the max pressure, which makes me think is just an offset. Any suggestions?
Thanks


Sent from my iPhone using Tapatalk

Re: Pump gauge starting at 7bar

Posted: Sun Oct 07, 2018 1:04 pm
by chas
The way to "reset" the pressure gauge is to buy a new one! What you're describing is the typical failure mode of the pressure gauges.

Re: Pump gauge starting at 7bar

Posted: Sun Oct 07, 2018 10:10 pm
by Bostonvivaldi
Thanks Chas.


Sent from my iPhone using Tapatalk

Re: Pump gauge starting at 7bar

Posted: Tue Oct 09, 2018 10:54 am
by chas
I should have mentioned one other important item. Even though this may not have been the cause of your gauge failure, the #1 cause is dropping or excess jarring of the gauge.

Since you don't know what the shipper has done with the gauge enroute to your house, always check that the new gauge is properly reading zero before you install it. If not, return it for a replacement as many times as it takes to get a good one.