Page 1 of 1

dead steam heater element

Posted: Fri May 26, 2006 5:42 pm
by lexbro
:cry: Hello, my name is Lex Browning. I live in Portland Or. and have owned an S1 for three months. I'm very happy with the unit but my steam heater element has died. I'm waiting on a replacement from Chris's (thanks to Roger in service who's been great to work with) and I'll put in myself. Are there any factors which might have contributed to this failure -- leaving the machine on too long, etc.? What's to keep the next one from failing too?

Posted: Sat May 27, 2006 12:20 pm
by admin
I'm not aware of anything you could have done to cause this. Had it been caused by failure of any of the steam boiler sensors, I think that would have been obvious via other symptoms prior to failure.

I assume you are aware of the documentation on replacement of the heater element located here: http://www.rimpo.org/s1/S1Boiler.html

Posted: Sat May 27, 2006 11:15 pm
by lexbro
Thanks for your reply Mr. Rimpo -- I've studied those pictures gratefully. I'll take some additional ones since a few production changes have occurred. :D

I hope the temp probe didn't fail first. My wife heard a funny noise and shut the machine down while I was gone...