I've been reading the very informative thread "DIY PF pressure gauge" http://www.rimpo.org/wforum/viewtopic.php?p=1738 and am going to hit Home Depot tomorrow and put one of these beasties together.
So a few questions:
a) If I create a pressure gauge that can measure "dynamic" pressure, or pressure with an outlet of 2 oz of water in 25 seconds, are people finding that 9 bar dynamic is recommended? Higher? Lower? Why would any vendor set the default to 10 when the conventional wisdom (seemingly) everwhere seems to advocate low 8s to 9? Is there a benefit to 10?
b) How does flavor change between higher and lower brew pressure values?
Thanks!
Jason
Brew pressure effects on flavor?
General Questions and Comments that fit no specific category.
Post Reply
1 post
• Page 1 of 1
Jump to
- General
- ↳ WELCOME TO THE S1CAFE
- ↳ General Q&A
- ↳ Maintenance and Repair
- ↳ 2008 V2 Upgrade Archives
- ↳ V2 Controller Board Upgrade Q&A
- ↳ Progressive Pre-infusion Upgrade Q&A
- ↳ Post Installation Discussion on New Temp Offset Option
- ↳ Generic Discussions about Pre-infusion
- ↳ Post Installation Discussion on Programmable Preinfusion
- ↳ Post Installation Discussion on Progressive Preinfusion
- ↳ Suggested Improvements
- ↳ Swap Meet
- ↳ Tips & Tricks
- ↳ Pursuit of the God Shot
- ↳ Pride Page
- ↳ Accessories
- ↳ Triple Baskets
- ↳ Tampers
- ↳ Temp Measurements & Tools
- ↳ Coffee Beans, Grinders, & Roasters
- ↳ Roaster Equipment and Use
- ↳ Coffee Grinders
- ↳ Green Beans & Their Roasting
- ↳ Pre-Roasted Beans
- ↳ Vivaldi Video Villa
- LaSpaziale S1 Dream & S1 Dream T
- ↳ S1 Dream & S1 Dream T Pre-launch Discussions
- ↳ Dream and Dream T Common Feature Discussions
- ↳ Dream T General Q&A
- ↳ Dream T Day One Issues
- ↳ Dream T In Warranty Issues
- ↳ Dream General Q&A
- ↳ Dream Day One Issues
- ↳ Dream In Warranty Issues
- LaSpaziale S1 Vivaldi II & S1 Mini-Vivaldi
- ↳ Mini General Q&A
- ↳ Mini Day One Problems
- ↳ Mini In Warranty Issues
- ↳ Mini Out-of-Warranty Issues
- ↳ VII General Q&A
- ↳ VII Day One Problems
- ↳ VII In Warranty Problems
- ↳ VII Out-of-Warranty Problems
- LaSpaziale S1 V1
- ↳ S1 General Q&A
- ↳ S1 Operational Problems